With Love.... From IML:  The NEW Hold


We had more fun with one of our more kinky NEW products at this past International Mr. Leather (IML).  

Check this out if you want something wider, bolder & bigger: The Hold Cock & Ball Cage. It has a 1.5" (38 mm) bandwidth (our widest) and is available in three interior diameters [1 3/4" (44.5 mm), 1 7/8" (47.6 mm) and 2" (50.8 mm)] so you can lock up your cock and balls in a wide cylinder of quality stainless steel. With this ring you can rock a wider cock ring yet allow your balls to drop through, hang free and not feel like they are pulled up to your chin.

We'll admit that this new piece of man-gear was inspired by hot memories of sweaty wrestling matches, steamy locker rooms and coach in his tight polyester shorts. This may take you back and remember those tight, warm Full Nelson holds!  You can squirm but this is one firm grasp that will not let you go!


The NEW HOLD:  The Hold Cock & Ball Cage - from gear essentials


Putting it on for the first time can be a challenge. Just slip the larger half over your cock and balls and push it snugly against your pubes with the slotted side down. Let your balls drop through the wide slot (see the product picture below--which shows The Hold upside down so you can see the interior finish) and then slide the head of your dick through the outer ring. Pull the two halves together so you can line up the screw with the hole (now there's a life theme for ya!) Hand tighten the two screws until The Hold is firmly locked down. (The two halves have to be aligned for the screws to go in smoothly.)  

Based on our experience (and customer feedback), getting into The Hold gets much easier with practice!

Note that the band closest to your pubes is the wider of the two rings--this allows you to get most of your balls in the indentation (wide slot) before securing the outer ring to minimize the risk of pinching. The outer ring tapers to a narrower opening which adds weight and acts as a shaft ring. For some this gives an increased shaft pressure that they have never experienced before. Like any ring, it restricts blood flow in your dick so your shaft gets even bigger. The feedback on this feature has been hugely positive.



The Hold Gives a Grip that Hugs your Balls & Shaft:  See How He's Chubbing Out? 


Can You Jack with It?

You can but you will notice that you only have room for a shorter stroke. Remember that the ring is taking up 1 1/2 inches of prime penile real estate! Depending on your preferred masturbation technique this may or may not matter. For example, if you get off on the knob twist, you are still good to go. We found that it forced us to be creative and try some different techniques--it was all good!


Can You Fuck with It?

We have heard a couple of responses:

  • "No thanks, I want more depth to my fuck and this is cramping my style."
  • "I love it, the combination of cock ring and built in shaft ring made me HUGE and the fucking is fucking awesome!"
  • One IML customer stopped back to report that he took the outer ring off for fucking--this gave him the room he needed for the depth of thrust that he and his partner enjoy while the base ring gave him the support and fullness he likes.



An Inside Look

Give it a whirl and have some fun with it!

gear essentials…Sex is Better here! ENJOY!


WHERE TO FIND IT:  Hold Cock & Ball Cage:  http://gearessentials.com/collections/cockrings/products/the-hold-cock-ball-cage



(Photos by Jay Williams. Ryan is not pictured.)



Write a comment

Comments are moderated